Classic AutoAir Perfect Fit-Elite Series Instructions d'exploitation télécharger pdf (Page 10)

As shown in picture it is necessary to rotate the assembly and slide over the screw that will be

under the switch. This screw will need to be

tightened with a wrench.

Locate in the control sack kit the Connecting Wire

and (1) 3/16” push nut.

Hook the wire through blower switch hole in the

lever and then over the Control Lever. Use push

nut to hold the connecting wire.

The next process is as simple as connecting cables to your OEM control head, placing control

head upside down.

CONNECTIONS ARE FROM UNDERSIDE OF CONTROL HEAD

Locate your E-Z Wire harness (green harness) from your control sack kit . Insert cable integrator

labeled MODE CONTROL ( green, yellow, blue wires ) and attach to the bottom arm of your

OEM control head. Place loop over post and attach with (1) push nut provided. Next attach (1)

cable clip provided to control bracket and tighten on OEM control head where the OEM cable

was attached previously. Make certain the cable integrator is flush with OEM control head

assembly as shown on next page.

Locate your E-Z Wire harness (green harness) from your control sack kit . Insert cable integrator

labeled TEMP CONTROL ( purple, brown, white wires) and attach to the middle arm of your

OEM control head. Place loop over post and attach with (1) push nut provided. Next attach (1)

cable clip provided to control bracket and tighten on OEM control head where the OEM cable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Pas de commentaire

Classic AutoAir Perfect Fit-Elite Series Instructions d'exploitation Page 10